Kleeco Tripod Designed Power Boat Stands

Each Kleeco power boat stand manufactured by Lake City Industries is stackable, and tripod designed for the greatest stability. Each power boat stand is constructed from solid coated metal rods with chrome plated screws that are designed to prevent rust. They are designed with straight heads, which are necessary for properly storing a power boat. If your power boat has a more sharply angled hull, you may need to purchase sail boat stands. All of our boat stands have a large surface bearing area, to make it easier to stabilize and store your vessel.

The Kleeco power boat stand line is available in seven different sizes, from 12” to 72” in height. Each stand is priced to be as affordable as possible, and you or your marina can save money by ordering multiple power boat stands at once. Keep in mind that you must use at least four boat stands for your power boat. If you have a larger power boat, you should use two boat stands for every 8-10 feet of boat length to keep your boat stable. Remember to always use blocking or keel stands to support the weight of your boat.

Directions for Setup and Placement

When setting up your stands, place the rear stands close to the outboard corners with the adjusting screw as perpendicular to the hull as possible. Place all stands with the point of the triangle facing away from the center of the boat. This permits placing dunnage under the tip of the base to conform the pad to the hull. If the ground is soft, be sure to use suitable dunnage, such as plywood, under the stands in order to get full contact with your boat. To position your stand against the hull, hold the screw with one hand, raise the screw with the pad to your boat hull, spin the wing nut with your other hand, and continue to tighten until desired tension is realized.

Layout Design	Sample Boat Stand	More Samples